A simple tutorial step by step to implement a useful front usb on your computer. If your computer does not have a front port, do not follow complicandote stirring the rear cables to connect your Flash drive or digital camera.
Parts and pieces
-A 2 × 5 connector (or according to your motherboard)
-10 wire flat cable
-Welding, cable, saw or knife, adhesive
Bases of the usb port
The following images show the assignment more common PIN of the usb port.
Pictures extracted from www.frontx.com/ cpx101_2.html
Preparing the Cabinet
First that nothing, what use is a bad expansion pci card:
Now, using the same piece of card as mold to cut cabinet:
Short card pci ports:
Now, according to the schemas, with one of the ports one cables and thus with Connector 2 × 5 which will go to the motherboard:
Finally paste the port with the adhesive to the Cabinet:
An important part of this simple work is properly connect each wire port. Probably your motherboard does not have any of the above pin voltage, marked as s-gnd in this Figure.